A B C D E
inn·001/16 10÷16mm 10x1 110mm 300 4mm
inn·001/16-b 10÷16mm 8x1 110mm 300 4mm
inn·001/23 16÷23mm 10x1 110mm 300 4mm
inn·001/23-b 16÷23mm 8x1 110mm 300 4mm
inn·001 test

Gripper inn·001 inserted and ready to testing.

The Universal Leak Test Gripper is an innovative tool which is applied in an extremely simple way to the tap, in order to test the sealing of the cartridge or the whole fusion.

inn·001-1
inn·001-2
inn·001-3
inn·001-4
inn·001-5
inn·001-6
inn·001-7
inn·001-8
inn·001-9
inn·001-10
inn·001-11
inn·001-12

The tool is designed for manual testing of small lots of production, in order to eliminate the construction of appropriate masks and reduce test time and retooling.


Typically the tool is used hung up by a rocker arm and doesn’t need any maintenance, except to make a periodic replacement of the O-ring seal.

inn·001 excursion

The use of gripper is facilitated by its travel.

Fitting/Removal

Calibration

Calibration

The movements between the O-Ring seal happen just in the first 30/40 working hours for a normal matching of the mechanical parts. To eliminate the movement you need to keep blocked the nut self-locking of 8mm with the opposite wrench using the open gripper and go on with a flat screwdriver on the top of the tie until the O-Ring and the intermediate washer finishes moving.


WARRANTY

The gripper has a warranty of 2 years only if it is correctly used and not forced or modified using non original components.
Use it just with air and light gases.
Do not immerse it in the water or corrosive elements.


MAINTENANCE

Replace the O-Ring just with the one indicated periodically using grease so that you can optimize and guarantee the functionality:
(inn·001 - 10mm) O.R. 5,23 x 2,62. O.R. 4,48 x 1,78
(inn·001 - 8mm) O.R. 3,6 x 2,4. O.R. 3,5 x 1,5

WARNING

The acceptance test has been done with air and light gases with the pressure of 8 bar; higher pressures do not damage the components and do not create risks for the worker, but they do not guarantee the efficiency.
If you do not use the gripper for a long time, you should lubricate the movements and put it in a dry place.

Via Vigne, 12 Raffa di Puegnago, 25080 (BS) - Italia
P.I. IT01785160985
Tel. +39 0365651840
Mob. +39 3356927997 - E-mail: info@innok.it